NORDBERG ROCK CRUSHER PROCEDURE DEVELOPMENT

Nordberg Rock Crusher

As a Metso approved overhaul facility for various models of Norberg rock crushers, CME developed written inspection procedures, a checklist, specialized methods and tooling to dismantle and reassemble. We developed production and QA forms to record NDT results and measure found conditions and dimensions. CME identifies cracks, distortion and component wear. From this, a repair…

Read More

OVERHAUL DIESEL ENGINE GENERATORS

OVERHAUL DIESEL ENGINE GENERATORS

The Canadian Navy operates several specialized pieces of equipment harbour and barges to service the fleet. This refuelling and electrical back up power vessel project required removal of old diesel power generator sets and re installation of modern power generator sets and electrical panels. Equipment removal on ships require selective removal or avoidance of obstructions.…

Read More

POWER STATION EQUIPMENT REBUILD

Power Station Equipment Rebuild

Edmunston energy’s vertical Kaplan power station had a worn components and was out of alignment. The entire dam had settled and the unit was no longer plumb. CME documented dismantling under our specialists’ experienced supervision. We determined that the cause of out of plumb was settling of the dam itself. We removed and serviced worn…

Read More

PRESSURE VESSELS AND HEAT EXCHANGERS

Pressure Vessels Heat Exchangers

CME is qualified to build pressure vessels and pressure piping under ASME “V”, “p” and “R” code stamps. Marine pressure vessels and piping involving Lloyds or DNV classifications can also be reliably fabricated using ASME accepted duality management systems and ASME welding procedures. Alterations are qualified under national Board “R” stamps. Appropriate material traceability records,…

Read More

VARIABLE PITCH RUNNER REPAIR

Variable Pitch Runner Repair

This variable pitch runner had damaged oil seals and damaged pitch adjustment. CME dismantled and repaired binding works, replaced oil seals, repaired pivot bushings and mechanical damaged area of runner shaft. Entire sheet runner was dynamically balanced. CME’s large swing lathe can handle the large diameter turbine with long shaft attached as are an assembly…

Read More

SHIP BULBOUS BOW STEEL PLATE REPAIR

SHIP BULBOUS BOW STEEL PLATE REPAIR

Emergency call for repair since the ship is loaded with Cargo. CME response promptly with around the clock deployment of experienced skilled personnel. Preparation for working on the water with all the logistic to support the operation. Mobile Cranes, Barges and build working platform.

Read More

SIDEWINDERS

Sidewinders

CME manufactures small steel work boats and tugs for the logging industry. These powerful vessels range in size from 15 feet up to 30 feet, the most common of these vessels we build and sell are the 18 foot super winders. They are 18 feet in length with a beam of 8 feet and draft…

Read More

HYDROGRAPHIC SURVEY BOATS

Hydrographic Survey Boats

These boats chart the ever-changing river bottom to facilitate the dredging programs. CME built 2 ROV support vessels for Simon Fraser University and University of Calgary with similar features to this Hydrographic Survey vessel shown in the photo provided.

Read More

POLLUTION CONTROL LANDING CRAFT

Pollution Control Landing Craft

CME has built sizes from 20 feet to 50 feet for DND and the Canadian Coast Guard including constructing vessels for use in Nigeria where we went from design to delivery. CME has also constructed twin V6 Volvo Diesel engines, 330 horsepower each with a loaded speed of 25 knots on 11,000 LB payload.

Read More